Seam Phantom Rapid Z-Drums

The Rapid Z-Drum come in 1 ³ and 3"" diameter, vacuum brazed drum wheels. They are specifically designed for use with the Sink Bull

These are the bits you need to clean out the tight corner radius on square sink bowls. The bearings, if equipped, ride along the template and the coarse grit will remove the extra material left by the Rapid Z-Cut. The fine grit will further smooth the surface and leave it ready to polish.

They are also designed to match the height of the Rapid Z-Cut, so height adjustments on the Sink Bull are not required between bits. They are center water feed compatible (Note that Sink Bull does not use center water feed).

Advantages:

• Fits 5/8-11 arbor threads (also available in M14 thread)
• Height matched to the Rapid Z-Cut
• Center water feed
• Maximum RPM 8500
• Coarse Grit = approximately 30/40 grit
• Fine Grit = approximately 120/150 grit